Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MONITORS PROGRAMMING
P
rogramming the monitors.
Set to ON the switch number 2 of the configuration dip switch, that's
accessible by opening the terminal connector protection cover
(see door panel instructions manual).
The door panel will reproduce a sound to advise that the system
has entered into programming mode.
In systems with more than one door panel, the programming process
shall be done on the master door panel only.
Switch off the monitor to be programmed, by pressing
the lock release push button during 1 second.
Once the monitor is off, press the autoswitch-on push button.
While pressing the autoswitch-on push button,
press the lock release push button.
To show that the system is ready for programming,
the door panel will reproduce a sound and the picture
will appears on the monitor. At this moment, the
push buttons can be released. Lift the monitor handset.
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Make a call to check that the monitor has been succesfully programmed.
Repeat these steps to program the rest of monitors.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a sound to advise
that the system is still into programming mode.
21
Press the door panel push button that will
call to this monitor. At this moment
the door panel and the monitor handset
will reproduce a sound.
To program the monitor as master,
replace the monitor handset.
To program it as slave, press the lock
release push button.
22
b
d
a
c
e
F
unction push button.
During call reception and communication progresses allows the lock release activation,
with no dependence on the handset position.
During stand-by condition and with the handset lifted, allows to call to the master
porter's exchange.
T
erminal connector description.
+ _
A D
HZ-
TELEPHONE DESCRIPTION
D
escription of the T-940 Uno telephone.
a.
Telephone handset.
b.
Speaker grille.
c.
Microphone hole.
d.
Subjection hole.
e.
Telephone cord connectors.
f.
Function push button.
g.
Hook switch.
f
e
g
+ ,
–
:
positive, ground.
A :
audio communication.
D :
digital communication.
HZ- :
door bell push button input.
Publicidad
Tabla de contenido
