Seamax 80DB Manual De Instrucciones página 4

Get you pump and battery ready
 Choose the proper fitting for the air valve of your inflatable product. Put the valve at the inflation position.
Attach the correct valve adaptor to the inflation hose that comes with your pump. Attach the other end to
the pump (smooth round outlet on the pump)
 Connect the 80D pump's terminals to the battery paying close attention to the polarity. Make sure the
clips are on the same color electrode and properly connected. Otherwise the pump won't turn on or run
properly.
 If you have the 80DB model with the built-in battery, please make sure the battery has been charged. A
new fully charged battery should last 30 minutes or more for regular use. If the battery is low, please
charge the pump by using the charger comes with the package. Follow the same instructions as used for
the 80D model.
Using the pump - Inflation

Turn on the POWER switch and enter the maximum desired pressure by using the set pressure (UP)
buttons, the set pressure will be shown on the right hand side of LCD screen. Use the last button to
switch the pressure display mode between KPa and PSI.
 (10KPa = 100mbr = 1.45 PSI). Factory default working pressure is set as 25KPa (3.6 PSI).This pressure
is suitable for most inflatable boats.
 Min set pressure is 1 PSI (8Kpa), if you only need lower pressure than 1 PSI, you can keep monitoring the
screen pressure reading and stop the pump manually.
 Press the POWER button to start. During inflation, the left hand side of LCD screen should show the
pressure that the inflator has reached. As soon as the entered pressure has been reached, the inflator
turns off automatically. And the inflator can be turned off at any time by pressing the POWER button
again. Take off the air hose from the chamber once the pump stops pumping. It is possible to stop the
inflator at any time by pressing the (OFF) switch.
 The inflator operates in two stages which can be identified by the noise of the turbine at the beginning
followed by the piston. The inflator switches from turbine to piston automatically. If the chamber
pressure is over 7KPa / 1 PSI, the pump will start the 2
chamber's pressure, the pump won't turn on.
 Protect the inflator from sand & water by keeping it in the provided carrying bag when not in use. If sand
or water gets into the inflator and over the air filter holding limit, the air pump will be damaged and no
warranty covered.
Three Buttons Inflation Operating
nd stage only. If the set pressure is lower than the
PAGE 4