Operating Instructions; Temperature Selection; Care And Maintenance - Danby Designer DCRM31WDD Manual De Instrucciones

To avoid vibration, the unit must be set level. This is accomplished by adjusting the (1) front leveling leg located under the
refrigerator. The temperature of the refrigerator is controlled by setting the thermostat knob to a desired setting.

TEMPERATURE SELECTION

To start the refrigerator, turn the temperature control knob to
the position corresponding
graduated black dial) in Fig.
will vary depending on the quantity of the food stored, and on
the frequency with which the door is opened.
To tum the control to the OFF" position, rotate the control
knob to the "0" setting. After defrosting and if the refrigerator
has been left out of use for some time, set the control to
maximum for 2 to 3 hours before turning to the desired posi-
tion. If the refrigerator is not to be used for long time peri-
ods, disconnect the plug and leave the door partially open.
This will help reduce the mold/mildew from accumulating
inside the refrigerator cabinet.
DEFROSTING
Defrosting of your refrigerator should take place
whenever ice build-up inside the freezer compartment reach-
es 114• (6mm) thick. Defrosting may take a few hours,
depending on the amount of accumulated ice and ambient
indoor temperature. To speed up the defrosting process,
remove all frozen foods from the freezer section. Leaving the
door partially ajar for a short period of time will also speed up
the process.
Note: Never use sharp or pointed instruments to
remove ice from the freezer compartment. The freezer
compartment contains refrigerated gas lines and if
accidentally punched/pierced,
refrigerator inoperable and void the manufacturers warranty.
DO NOT ALLOW THE REFRIGERATOR TO CONTINUE
OPERATION IF THE FREEZER COMPARTMENT IS
PIERCED.
After defrosting is complete, set the control to maximum for 2
to 3 hours before returning to the desired position. When the
refrigerator is not to be used for a long period of time, discon-
nect the appliance from the electrical supply and leave the
door partially open. This will help to reduce mold and mildew
build-up.
Note:Wait 3 to 5 minutes before attempting
refrigerator if operation has been interrupted.

OPERATING INSTRUCTIONS

to
the desired cooling (on the
A. The refrigerator temperature

CARE AND MAINTENANCE

will render the
to
restart the
IFig.AI
5