Linksys WRT54G Guia De Inicio Rapido página 8

J
Wireless SSID Broadcast. When
wireless clients survey the local
area for wireless networks to
associate with, they will detect
the SSID broadcast by the
Router. To broadcast the
Router's SSID, keep the default
setting, Enable. If you do not
want to broadcast the Router's
SSID, then select Disable.
K
Change these settings as
described here and click the
Save Settings button to apply
your changes.
L
Power your broadband
modem off and back on
again.
M
Restart or power on your PCs so
they can obtain the Router's
new settings.
N
To test the Router's settings,
open your web browser from
any computer. In the browser's
Address field, enter
www.linksys.com/registration
and press the Enter key.
Congratulations! The installation of
the Wireless-G Broadband Router
is complete.
8
Once the Router is
IMPORTANT:
configured, wireless security,
either WEP or WPA, should be
configured to prevent security
breaches in your network.
NOTE: If your wireless adapters
support Secure Easy Setup (SES), you
can use the SES button on the Router
to set them up.
To do this: Press the orange Cisco logo
on the Router's front panel for at least
two seconds. Wait about 10 seconds.
When the logo turns white and begins
to flash, press the adapter's
SecureEasySetup button. The Router's
Cisco logo will stop flashing when the
device has been added to the
network. Repeat this procedure for
any additional SecureEasySetup
device.
Refer to the User Guide for further
instructions.