Operation - Albrecht Tectalk Float Manual Del Usuario

Operation

Power ON-OFF
1. To turn on the unit, press and hold the ON-OFF button, the LC
Display will show the channel number and the CTCSS code
number.
2. To turn off the unit, press and hold again the ON-OFF button.
Using the radio
The unit has 8 main channels and 38 CTCSS codes for each
channel. You can communicate with any other radios that are using the
same main channel & CTCSS code.
Speaking to other radios
1. Press and hold the PTT button, the TX icon will be shown in the
LC Display.
2. Hold the unit in a vertical position with the microphone
at 5-8 cm from the mouth and then speak.
3. When you have finished speaking, release the PTT button.
4. Now you are ready to receive incoming signals. Adjust the
volume to the desired level if necessary.
Time-out Timer (TOT)
The Time-out Timer disables transmitting after 3 minutes maximum
transmission period. Transmitting can only be reactivated by releasing
and pressing the PTT button again.
Using a Headset
1. Connect the headset to the jack on top of the device.
(to connect accessory with a 2.5 mm stereo plug use the
supplied adapter)
2. Press the PTT button on the earphone to speak and release it
to listen.
3. Adjust the volume if necessary.
Please note that the degree of protection IP67 only applies if the
headset jack is sealed with the rubber stopper.
24 English