Eaton 6LSQA Serie Instrucciones De Instalación

IL520012EN
Installation Instructions - 6LSQA Series Recessed
Adjustable LED Trims
Instructions d'installation - Garnitures à DEL en retrait réglables de
la série 6LSQA
Instrucciones de instalación - Terminaciones ajustables para LED
empotrados de la serie 6LSQA
IMPORTANT: Read carefully before installing fixture.
Retain for future reference.
WARNING
Risk of Electrical Shock! Disconnect power at fuse or
circuit breaker before installing or servicing.
WARNING
Risk of Fire! For Non-IC fixtures do not install
insulation within 3 inches (76 mm) of any part of the
luminaire fixture or in a way that may entrap heat.
WARNING
Installation and servicing to be performed only by
qualified personnel. If not qualified, consult an
electrician.
6LSQA0
Figure 1
Trim Installation
1. Remove Trim from protective packaging and place Trim
Square (optional) over reflector before installation.
2. Install Trim Assembly by inserting Mousetrap Springs
into Square Aperture inside collar (Figure 2).
3. For angle cut trims, place tall side of reflector on the
same side as the Rotation Adjustment Thumb Screw.
Do not energize the LED Engine until the protective
cover has been removed with the optic and lower trim
properly installed. Do not touch the surface of the LED
as it may damage the light engine.
SAFETY: When using electrical equipment, basic safety
precautions should always be followed, including the
following:
1. This unit is for recessed mounting only. Do not use in
hazardous locations nor near gas or electric heaters.
2. Do not use this equipment for other than the intended
use.
3. Install only in accordance with National Electrical Code
and local regulatory agencies' requirements.
6LSQA1
Cleaning
To Clean Trims:
1. Gently wipe with soft, clean, dry lint free cloth to
remove dust.
2. Wipe with mild detergent solution on a soft, clean cloth
to remove fingerprints and stains.
3. Rinse with clean water and dry with soft, clean, dry
lint free cloth.
Brand Logo
reversed out of
black
INS # INS #
WARNING
6LSQAL0 6LSQAL1