Switching On And Off; Operating The Trimmer - Black and Decker GH710 Manual De Instrucciones

ATTACHING EXTENSION CORD
• Anextension cord retainer
(figure H)isbuilt i ntothe switch
handle t hatprevents thecord
from coming u nplugged. Touse
thisfeature, simply d ouble t he
extension cord about 8 inches
(203mm) from theend, a nd
insert i tinto theslot(10) i nthe
end ofthehandle a rea. H ook
theloop formed b ydoubling the
cord over t hetab(11). Gently
tugonthe cordtoinsure t hat i tis
firmly retained inthe trimmer's
handle. Plug thereceptacle end oftheextension cord intothe
plug blades ( 12) i nthetrimmer.
WARNING:
Always use proper eye protection that conforms
to ANSI Z87.1 (CAN/CSA Z94.3) while operating this power tool.
CAUTION:
Inspect area to be trimmed and remove any wire,
cord, or string-like objects which could become entangled in the
rotating line or spool. Be particularly careful to avoid any wire which
might be bent outwardly into the path of the tool, such as barbs at the
base of a chain link fence.
SWITCHING ON AND OFF
• To switch the tool on, squeeze the trigger
lever.
• To switch the tool off, release the trigger
lever.
• With the unit on, angle unit and slowly
swing the trimmer side to side as shown in
figure I.
OPERATING THE TRIMMER
• Maintain a cutting angle of 5° to 10° as shown in figure J. Do
not exceed lO°(figure J1). Cut with the tip of the line. To keep
distance from hard surfaces use edge guide (7). Pull the guide out
until it snaps securely into place.
/, /
iJ _ )'/ ',