Constant Voltage Operations; Constant Current Operations - Fisher Scientific FB3000-2 Manual De Instrucciones

O
PERATION

Constant Voltage Operations

From the mode selection screen, select constant voltage
operation by pressing the appropriate function key located to
the right of the display. To get to the selection screen from an
operating screen, press Exit, or cycle the control logic off and
then back on by pressing the gray ON/OFF key and selecting
MANUAL. The FB3000 will display the last saved setpoint for
constant voltage mode. To switch between
volts/current/power and time/volt-hours/temperature, press
function key F1. To change a parameter, press the function
key located to the right of the display, next to the parameter
you wish to change. The FB3000 will allow a new value to be
entered using the keypad numeric keys. Press the function
key labeled "Enter" to complete the new setting. Press Clear
to erase previous keystrokes. Press Exit to cancel entering a
new value. The FB3000 will not accept a voltage setpoint
outside of the allowed range. Press Clear to re-enter an
appropriate value.
The limit parameters are normally set to the power supply
maximum values. The FB3000 will not accept a limit parame-
ter outside of the allowed range.
In addition, the FB3000 will never exceed the maximum
power output specification of 400W.

Constant Current Operations

From the mode selection screen, select constant current oper-
ation by pressing the appropriate function key located to the
right of the display. To get to the selection screen from an
operating screen, press Exit, or cycle the control logic off and
then back on by pressing the gray ON/OFF key and selecting
MANUAL. The FB3000 will display the last saved setpoint for
constant current mode. To switch between volts/current/power
and time/volt-hours/temperature, press function key F1. To
change a parameter, press the function key located to the
right of the display, next to the parameter you wish to change.
The FB3000 will allow a new value to be entered using the
keypad numeric keys. Press the function key labeled "Enter"
to complete the new setting. Press Clear to erase previous
keystrokes. Press Exit to cancel entering a new value. The
FB3000 will not accept a current setpoint outside of the
allowed range. Press Clear to re-enter an appropriate value.
The limit parameters are normally set to the power supply
maximum values. The FB3000 will not accept a limit parame-
ter outside of the allowed range.
In addition, the FB3000 will never exceed the maximum
power output specification of 400W.
9