Recalling Measurements In Memory - MABIS 04-596-008 Manual De Instrucciones

Taking Your Blood Pressure Reading
11. When all the air is deflated, the measurement is complete. The unit will
pulse rate, Fig. 7.
display your blood pressure (systolic and diastolic) measurements and
12. Record your readings on the chart that is provided at the end of this
manual.
13. At this point, your measurements will be automatically saved in
memory.
14. To conserve the batteries, press the 'START" button to turn the power off.
Otherwise, the unit will automatically shut off after
approximately 1 minute.
down into the 'off' position, Fig. 8.
15. After you are done using the monitor, slide the on/off switch
16. Disconnect the tubing from the monitor prior to storing.
NOTE: This monitor inflates the cuff to approximately 190 mmHg
or 40 mmHg higher than the last systolic pressure stored in
memory. If the system detects that the cuff needs additional
pressure, it will automatically reinflate to approximately 40 mmHg
higher than the last pressure level.
Fig. 7
Fig. 8
– 14 –

Recalling Measurements in Memory

You can recall up to 120 total measurements in memory (60 per memory bank). These
measurements can be shared with your physician or trained healthcare professional.
NOTE: Turn the monitor on by sliding the switch on the side up to the
'on' position.
1. Press and release the MEM button. The unit will display either
many measurements are stored within that bank, Fig. 1.
U1 or U2 depending upon the user bank selected. It will also show how
2. To select the appropriate user bank press the START button to switch
between U1 and U2.
3. Once the desired user memory bank is selected, press the MEM
measurements stored in memory, Fig. 2. Press the MEM button
button. The first reading displayed is the average of the last three
again to scroll through the saved measurements. After you've scrolled
through all the readings, the unit will automatically turn off.
NOTE: Each memory bank can store up to 60 readings. When the number
of readings exceeds 60, the oldest data will be replaced with the new record.
To erase all stored measurements:
1. Press and release the MEM button. The unit will display either U1 or
U2 depending upon the user bank selected and how many
measurements are stored within that bank.
2. Select the desired user bank by pressing and releasing the
MEM button.
Fig. 3. This indicates that all measurements within the selected memory
3. Press and hold down the MEM button until two horizontal lines flash,
bank have been erased.
– 15 –
Fig. 1
Fig. 2
Fig. 3