Blue Hawk SGY-NR-KITC Manual De Instrucciones página 15

OPERATING INSTRUCTIONS
4. Air supply
When connecting air supply, always keep hands and body away from discharge area of tool.
A filter regulator-lubrication (not included) is required and should be located as close to the
tool as possible.
Make sure the air pressure is set at the correct range of 70 - 110 PSI before using. Never
exceed 120 PSI.
4
Quick
Connector
Tool
5. Loading fasteners and operating
Release the latch and pusher; slide the pusher against the nails.
Connect the tool to the air supply.
Test the drive depth in a sample piece of wood before using. The nail may be driven in too
far, or not far enough. The air pressure regulator may require adjustment to ensure the nails
are driven to the correct depth. If the air pressure regulator is adjusted, make sure it does
not exceed 120 PSI.
Repeat the drive depth test on a sample piece of wood until the proper depth of the driven
nail is achieved.
Quick
Coupler
Air Hose
Quick
Oiler
Connector
Quick
Coupler
Regulator
Not all components shown are included.
15
Filter
Air
Compressor
www.lowes.com
®