Electrical Shock Hazard - Electrolux ELFE4222AW Manual De Instrucciones

10 Installation Instructions
5. Reinstall the terminal block access cover.
WARNING

ELECTRICAL SHOCK HAZARD

Do not operate dryer without terminal cover
in place. A correctly installed terminal block
cover also acts a qualified strain relief for the
power cord.
IMPORTANT
If moving dryer from a 4-wire system and
installing it now in a 3-wire system, move the
internal ground wire from the center terminal
back to the GREEN screw under the
terminal block.
Electrical Connection
(Non-Canada) - 4-Wire Cord
30 AMP
NEMA 14-30
Ground GREEN wire
1
Neutral White wire
2
NOTE
Two cords shown above with different
terminal types.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before
servicing could result in personal injury or
even death.
4-wire receptacle
(NEMA type 14-30R)
1
1. Turn off power supply to outlet.
2. Remove the three screws securing the
terminal block access cover in the upper
corner on the back of the dryer.
NOTE
Terminal screws were shipped from the factory
temporarily attached inside the access cover.
Terminal block access cover
1
Access cover screw
2
DO NOT REMOVE - screw next to this text
3
must not be removed.
3. Disconnect the internal (WHITE) dryer
harness wire from the (GREEN) ground
screw next to the terminal block.
2
Internal ground (GREEN screw)
1
Internal dryer harness (WHITE wire)
2
1
2
3
2
2
1
2