Automatismos Pujol RADIUS Instrucciones De Instalación Y Reglaje página 24

Fault
The door does not open or
close
The door does not open, or
does not open completely
The door does not close, or
does not open completely
The door opens or closes by
itself after being connected
to 220 V
The door carries out the
photocell function and
automatic door close in
reverse
NOTE: If the door does not work after verifying the above described solutions, it is
advisable to replace the electronic equipment or contact our technical department
After Sales Service
34-9
Possible Cause
Fault in electric supply
Connector incorrectly connected
Thermal protection activated
Lack of strength
Motor unlocked
Item of electric panel
short-circuited
Reversible Version
The electro-lock does not
work
Reversible Version
The electro-lock does not
work
Time of functioning
The photocells or safety
bands are incorrectly
connected
Time of functioning
One of the controls
connected to the terminal in
the electric panel is closed
The door is on automatic
close
The connections are
incorrect
automatismos@pujol.com
02 199 947
automatismos pujol - 24 - english
radius
Check the supply at 220V and the fuse in the electric
panel
Connect according to the instructions
Wait 15 minutes for the motor to cool
Adjust the power gauge in the panel
Lock the motor with the unlocking handle
Disconnect all the items in the terminal, and reconnect
them one by one. Check the connections to the
electro-lock
Check the mechanical fitting
Check the electro-lock connections
Check the mechanical fitting
Regulate the power gauge in the panel
Check the electric supply of the photocells or bands,
that they are correctly connected and that there is no
obstacle
If there is no photocell unite the terminals in the
electric panel.
Regulate the power gauge in the electric panel
Connect the accessory to an opened position (pusher,
receiver...)
Deactivate the automatic close lever
Disconnect the electric supply and change the position
of the cables of the motor
Solution