Bobrick ADA Serie Guia De Incio Rapido

Technical Data
Specify Voltage Required:
B-7120 Dryer with White Painted Cover

B-7128 Dryer with Stainless Steel Cover

Specify model number followed by voltage required. Example: B-7128 115V for 115-volt Stainless steel cover hand dryer.
MATERIALS:
Cover — 22-gauge galvanized steel with exposed surface type-304 stainless steel with #4 satin-finish vertical grain (B-7128) or
22-gauge mild steel zinc plated with high-gloss white epoxy paint finish (B-7120) covers with UL 94-5VA black plastic trim and
side panels. Cover equipped with uniquely designed dual air outlets. Air-inlet is equipped with vandal-resistant grille. Cover
projects no more than 4" (100mm) from wall and is secured to mounting base with two vandal-resistant, recessed hex screws.
Mounting Base — 20-gauge (1.5mm) plated steel with four 0.236'' (6mm) diameter mounting holes.
Motor — Universal, 1/7 hp, 8000 rpm, on resilient mounting. Sealed ball bearing at drive-shaft end and self-lubricating sleeve
bearing at nondrive end. Equipped with automatic thermal-overload switch.
Fans — Two balanced, double-inlet centrifugal fans are mounted on motor shaft; directs airflow over heating element at 71 cfm.
Heating Element — Two coiled nickel-chrome heating elements are mounted in mica frame and protected by automatic
thermal-overload switches. Heating elements, heat air without hot spots — inaccessible to vandals.
Electronic Control — Infrared sensor automatically turns dryer on when hands are held under air-outlet opening and across
path of sensor. Remove hands from path of sensor and dryer stops. Electronic sensor has automatic shutoff approximately
1-1/2 minutes after dryer turns on if an inanimate object is placed across air-outlet opening. After inanimate object is removed,
electronic sensor automatically resets itself and dryer operates normally.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions.
TrimLine™
SURFACE-MOUNTED
ADA DRYER
Specify Voltage Required:
115V AC, 15 Amp, 1725 Watts, 50/60 Hz, Single Phase, cULus Listed.

208–240V AC, 6.8-7.8 Amp,1400-1900 Watts, 50/60 Hz, Single Phase, cULus

Listed, VDE approved and CE marked.
13-25/32" 350mm
9-1/4" 235mm
Ø7/8" 22mm
Hole for between wall wiring
Ø 5/16" 8mm
1. 2. 3.
x 4
Ø7/8" 22mm
Hole for between wall wiring
Flange cutout for
surface mounting
B-7120
B-7128
RECOMMENDED MOUNTING HEIGHTS
C
Children's Washrooms, ages 3-4
Children's Washrooms, ages 5-8
Children's Washrooms, ages 9-12
Universal Design
Bottom screw hole of mounting base to finish face of floor
c
Finish Face of Wall
4"
100mm
S
S
4-1/8"
105mm
See Table for
Recommended Mounting
Height Off Floor
Revised 5/29/14
© 2014 by Bobrick Washroom Equipment, Inc.
36'' (915mm)
40'' (1015mm)
44'' (1120mm)
48'' (1219mm)
continued . . .
Printed in U.S.A.