Maytag MDB8989SHBK Manual Del Usario página 11

OPTIONS
Dries dishes with heat and a fan. This option,
Short
with the use of rinse aid, will provide optimum
Power
drying performance. Plastic items are less likely
Dry
to deform when loaded in the top rack. Turn off all
Fan Dry options for air dry.
Models)
Long
Uses heat and a fan for additional time to dry
Power dishes. For the very best drying performance, use
rinse aid and the Long Power Dry option. Turn off
Dry
all Fan Dry options for air dry.
Models)
Runs dishwasher at a later time or during off-peak
D
electrical hours. Select a wash cycle and options.
Press DELAY to cycle through the delay time
options. Press START. Close door firmly.
NOTE: Any time the door is opened (such as, to
add a dish), the START keypad must be touched
again to resume the delay countdown.
CONTROLS AND CYCLE STATUS
CONTROL
Hold 3 Sec
Canceling A Cycle
1. Open the door slightly to stop the cycle. Wait for the
spraying action to stop before completely opening the door.
2. Press CANCEL. The Cancel indicator will glow.
3. Close the door and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the dishwasher
drain completely. The Cancel indicator turns off after 2
minutes.
Changing A Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
1.
Open the door slightly to stop the cycle. Wait for the
spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed.
a. If cover is open cancel the cycle and start a new cycle
b. If cover is closed continue to next step
3. Press CANCEL twice to reset the control.
4. Select new cycles and options.
5. Press START.
PURPOSE COMMENTS
Press to START If the door is opened during a cycle or the power is interrupted, the START
a wash cycle. button light flashes. Cycle will not resume until START is pressed and
the door is closed. Push door firmly closed within 4 seconds of pressing
START.
Press to cancel Press and hold CANCEL for 3 seconds. Close the door firmly. The
wash cycle dishwasher starts a 2-minute drain (if needed). Let dishwasher drain
completely.
The display Your dishwasher has indicators that glow for Add Dish, Washing, Drying,
allows you Sanitized and Clean.
to follow the
The exterior status light on the front of the door panel will glow blue when
progress of the
washing, red while it is drying, and white when the cycle is complete.
dishwasher
cycle.
CAN BE WHAT IT DOES
SELECTED
Auto Uses a heating
PowerBlast element and fan
®
Normal
to speed drying
Quick times. Short
Power Dry option
is on when any
cycle is selected
except for Quick
and Rinse.
Auto Lengthens the
PowerBlast time that Long
®
Normal
Power Dry is
Quick active.
Available with Delays start of a
any cycle cycle by 8 hours.
Adding A Dish With Add A Dish Indicator
1. If Add a Dish indicator is lit. proceed to Step 2. If indicator is
not lit an added dish might not get cleaned.
2. Open the door slightly to stop the cycle. Wait for the
spraying action to stop, and then open the door completely.
3. Add the dish.
4. Press START keypad and close the door within 4 seconds to
resume the cycle.
ADDED TIME ADDED
WATER
TO CYCLE
GALLONS
(LITERS)
0:11 to 0:46 NA
0:43 to 1:20 NA
11