Publicidad
Idiomas disponibles
Idiomas disponibles
• External grille (I) made of high quality, impact and UV-resistant ABS, colour RAL 9010, with anti-insect net and water drip guard.
• Infra-red remote controller with touch technology, LCD display and wall base supplied as standard. Made from ABS, RAL 9010.
• The unit is double insulated: no earth connection is required.
• No need of condensation drainage system.
• IPX4 degree of protection.
• Power supply 220-240V~ 50Hz.
OPERATION
REMOTE CONTROLLER
AIR FLOW DIRECTION ICON
SPEED ICON
FILTER RESET ICON
MODE ICON
OFF BUTTON
external grille - installation
Ø5x40mm
MODE BUTTON
5mm
FILTER RESET BUTTON
The unit is supplied with an infrared remote controller (K) as standard, as well as its support base (L) which can be wall mounted. A
magnet keeps the controller attached to the base.
The controller is equipped with an LCD display to visualise the setting to be transferred to the unit; anytime a touch button is pressed, the
setting shown on the LCD display is transferred to the unit. The IR receiver (J fig. 1) is placed on the left side of the ventilation unit: it is
cambio batterie telecomando
recommended to point the controller towards the receiver when any setting needs to be transfered.
One remote controller can control more units.
To activate the remote controller it is necessary to insert two AAA type batteries (not supplied).
VENTILATION UNIT
When switched on the unit emits a long acoustic signal.
Through the IR controller the following functionalities can be activated/deactivated. When one setting is transferred to the unit, a short
acoustic signal is emitted and a green led flashes.
F
H
G
I
H
SPEED ICON
BOOST ICON
SPEED BUTTONS
AIRFLOW DIRECTION BUTTON
BOOST BUTTON
K
E
D
B
C
A
fig. 1
J
L
7
Publicidad
