Publicidad
Idiomas disponibles
Idiomas disponibles
K
Router table top
L
Insert plate
Set screw
M
Precision Insert Plate Installation
Kreg Precision Router Table Insert Plate Levelers method
1.
of the table-top opening, mating the curve on the raised portion of the leveler
with the radius corner of the opening. Firmly holding the leveler in place and
using the three mounting holes in the leveler flange as guides, drill pilot holes
into the table top. Fasten the leveler to the tabletop with three 1¼" coarse-thread
screws provided [ Drawing K ] . Repeat with the remaining levelers.
for use on router table tops with a minimum thickness of 1". For thinner tops, use
your own shorter screws.
Mating Curves
2.
each outside hole in each leveler, threading them in from the bottom until the tips
are ⅜" below the table surface.
3.
base to the insert plate using the screws supplied with the plate. For the Kreg
PRS4038 Precision Insert Plate, use the screws that were used to attach the
sub-base to the router base to attach the router base to the insert plate. Make
certain that the screws are long enough to fully thread into the router base. It
may be necessary to purchase longer screws. For fixed-base routers, install the
motor unit in the router base.
4.
Lock-down screw
resting it on the eight set screws. Using the hex wrench, adjust the set screws
from under the table to align the surfaces of the plate and the table. Check
the alignment with a straight edge. Make sure all eight set screws are in equal
contact with the insert plate
5.
countersunk holes in the insert plate and into the center hole on each leveler and
snug them down [ Drawing L ] . Some adjustment of the lock-down screws and
set screws may be necessary to fine-tune the alignment.
Hex wrench
1.
a flat-blade screw driver and ⅛" hex wrench, until the two are tightly secured
together [ Drawing M ] . When ready for use, thread the starting pin assembly into
the threaded hole in the insert-plate and tighten it.
Starting pin
Set screw
With the table top upside down, position an insert-plate leveler in one corner
ATTENTION!
The 1¼" coarse-thread screws provided with the levelers are
Using the ⅛" hex wrench, drive a ¼-20 x 1½" socket-head set screw into
For Kreg PRS4034 and PRS4036 Precision Insert Plates, fasten the router
Place the insert plate with the router attached in the table-top opening,
Thread the four ¼-20 x 1¾" machine screws (lock-down screws) through the
Finishing Up
Thread the ¼-20 x ¾" set screw into the bottom of the brass starting pin using
6
Publicidad
