Pulse Charging; Appliance Protection Function; Overheating Protection; Maintenance And Upkeep - Bosch C3 Instrucciones De Uso

Pulse charging

This is an automatic charger function which
cannot be selected manually. If the battery
voltage in 12 V mode is between 8 V (± 0.5 V)
and 10.5 V (± 0.5 V) at the start of charging,
the charger switches automatically to pulse
charging. On attaining a battery voltage above
10.5 V (± 0.5 V), the charger switches auto-
matically to the charging mode previously
selected. This enhances the charging process.

Appliance protection function

The charger switches to standby mode in the follow-
ing abnormal situations.
► Battery voltage < 6 V (12 V batteries)
► Open circuit
► Reverse polarity
In the event of reverse polarity, the LED
will also light up. If no other setting is made,
the system remains in standby mode.
In the event of a short circuit at the charging cable,
fuse (4a) prevents damage to the device and the
electrical system. Check fuse (4a) if Mode selection
is not possible.

Overheating protection

If the unit becomes excessively hot during charging,
the output power is automatically reduced to avoid
damaging the unit.
04.2015 | C3 | Battery charger
C3-Komplett-060613.indd 21

Maintenance and upkeep

Always unplug the mains connector before work-
ing on the charger.
The unit is maintenance-free.
► Switch off the unit.
► Use a dry cloth to clean the plastic surfaces
of the unit.
► Never use solvents or other aggressive
cleaning agents.

Disposal

Only for EC countries:
(9)
+ -
According the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.
The packaging is made of ecological materials
which can be disposed of at local recycling facilities.
21 | english
Never dispose of electrical
equipment together with
household refuse.
Automotive Aftermarket
07.05.15 13:14