SAFETY INSTRUCTIONS
Section 1
Important: Read all safety information prior to installation of the Controller.
NOTE
This is a SAFETY ALERT SYMBOL. When you see this symbol on the controller, pump or in this
manual, look for one of the following signal words and be alert to the potential for personal
injury or property damage. Obey all messages that follow this symbol to avoid injury or death.
Indicates an imminently hazardous situation which, if not avoided, will result in death or
DANGER
serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in death or
WARNING
serious injury.
Indicates a potentially hazardous situation which, if not avoided, may result in minor or
CAUTION
moderate injury.
CAUTION
Used without a safety alert symbol indicates a potentially hazardous situation which, if
not avoided, could result in property damage.
NOTE
Indicates special instructions which are very important and must be followed.
NOTE
All operating instructions must be read, understood, and followed by the operating personnel. CentriPro
accepts no liability for damages or operating disorders which are the result of non-compliance with the
operating instructions.
1. This manual is intended to assist in the installation, operation and repair of the system and must be kept with
the system.
2. Installation and maintenance MUST be performed by properly trained and qualified personnel.
3. Review all instructions and warnings prior to performing any work on the system.
4. Any safety decals MUST be left on the controller and/or pump system.
The system MUST be disconnected from the main power supply before attempting any operation
5.
DANGER
or maintenance on the electrical or mechanical part of the system. Failure to disconnect electrical
Hazardous
voltage
power before attempting any operation or maintenance can result in electrical shock, burns or
death.
6.
When in operation, the motor and pump could start unexpectedly and cause serious injury.
CAUTION
Hazardous
Pressure
Page 3