KENMORE ELITE HE4 110.8586 Serie Manual Del Usuario página 8

Power Supply Cord Direct Wire
Fire Hazard
Use a new UL misted 30 amp power suppmy cord.
Use a UL misted strain remief,
Disconnect power before making emectrical connections.
Connect neutraB wire (white or center wire) to center
terminal (silveO,
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 supply wires to remaining
2 terminams (gored).
Securemy tighten aiBemectricat connections.
Failure to do so can resumt in death, fire, or
emectrical shock,
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover,
Fire Hazard
Use 10 gauge somid copper wire.
Use a UL misted strain relief=
Disconnect power before making emectricamconnections.
Connect neutraB wire (white or center wire) to center
terminal (silver),
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 suppmy wires to remaining
2 terminals (gored).
SecureBy tighten aH emectrical connections.
FaiBure to do so can resuJt in death, fire, or
emectrical shock.
3. Assemble a 3/,,,(1.9 cm) UL listed strain relief (UL marking on
strain relief) into the hole below the terminal block opening.
Tighten strain relief screws just enough to hold the two clamp
sections together. Put power supply cord through the strain
relief. The strain relief should have a tight fit with the dryer
cabinet and be in a horizontal position.
A. Neutral grounding wire (green with yellow stripes)
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Terminal block cover and hold-down screw
4.
Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)