INVROHEAT IH-1810 Manual De Instrucciones página 6

INSTALLING YOUR HEATER
NOTE: Your heater has a special heat-resistant coating. This coating has a speci c odor that will sometimes be present
when the box is opened, a sort of 'new car smell' . When rst operated, the coating will produce this particular odor for
the rst few hours. If you are sensitive to odor, you may want to run the heater in a garage with the door open until the
odor disappears.
A
Hang the heater on the
wall using the hanging
cord (1).
Our heater is equiped with an auto turn-o function.
After 6 hours the heater will shutdown automaticly.
The GREEN "LED" will turn RED. By mannualy switch
the on/of button, the heater will power on. The heaters
sold in China do not have this function and need the be
powered down mannualy
When you use the heating on a plaster wall or on a wooden wall, the wall can become discolored, but
it can also overheat, causing the heating to deform. Request the special spacers from your supplier.
The heater has been in the box for a long time, so the heater is preformed. Take the
heater out of the box, hang it on the cord and turn it on for 20/30 minutes. You will
see that the heating will hang straight. Watch the special instruction video on our
website:
CHANGING THE WORLD OF HOME-HEATING
6
B
Ensure that the heater hangs
straight against the wall. Note
that the heat emitted by the
heater, may overtime discolor
certain surfaces.
https://vimeo.com/364047480
www.invroheat.com
C
Check the power cord for any
faults before plugging it into
pre dettermined socket
at page 3
WARNING: the heater will heat
up within 30 seconds.
D
Turn the heater on by plugging
the power cord into the power-
socket and switching the
ON/OFF button.
EN
E