Cleaning And Storage; Troubleshooting - N8WERK 15410D0 Manual De Instrucciones

10. Turn over the shaker and unscrew the
blade attachment.
11. If the blended ingredients are not to
be consumed straight away, screw
on the shaker one of the lids (5, 6 or
7). IMPORTANT: With the storage
lid, make sure that the sealing ring is
inserted correctly in the groove so that
the shaker does not leak.
12. Clean the accessories immediately after
each use to prevent germ formation (see
the "Cleaning and Storage" chapter). Do
not allow any food residues to dry on.

CLEANING AND STORAGE

Please Note!
■ The motor unit and the blade attach-
ments are not suitable for cleaning in
the dishwasher!
■ Do not use any sharp or abrasive clean-
ing agents or cleaning pads to clean the
device. These may damage the surfaces.
○ Wipe down the motor unit (2) if neces-
sary with a damp cloth.
○ Clean the blade attachment (4, 8) under
running water with a little detergent.
○ Clean the rest of the accessories with
warm water and detergent or in the
dishwasher.
○ Allow all parts to dry completely or dry
them with a tea towel before storing
them away.
○ Store the device in a cool and dry place
protected from dust and direct sunlight
out of the reach of children and animals.
L
Some types of fruit and vegetables
may stain the plastic parts. This
is normal and quite safe and does
not constitute grounds for warranty
claims.

TROUBLESHOOTING

If the problem cannot be solved with the
steps below, contact the customer service
department.
Do not attempt to repair an electrical
device yourself!
The device does not work.
The blade attachment (4, 8) is not correctly
screwed on the shaker.
► Correct the fit.
The blade attachment (4, 8) is not fitted
correctly in the motor unit (2).
► Correct the fit.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit.
The plug socket is defective.
► Try another plug socket.
There is no mains voltage.
► Check the fuse of the electrical distribu-
tor (fuse box).
The device switches off.
Food is blocking the blades.
► Detach the blade attachment (4, 8) and
carefully remove the blockage.
The device is overloaded because the
contents are too thick or something has
become caught in the blades.
► Detach the blade attachment (4, 8) and
remove some of the contents or add liq-
uid and carefully remove the blockage.
The device is overloaded because it was
switched on for too long without a break.
► Pull out the mains plug and allow the
device to cool down for a few minutes.
EN
15