Connection Procedure - Blaupunkt SILVERSTONE C34 Manual Del Usuario

Connections
Warning
• To prevent short circuit, remove the key from the ignition
and disconnect the battery's (-) terminal.
• This unit is designed for negative ground 12 V DC operation
only. You can not use it for 24 V or other types of car batter-
ies.

Connection procedure

Caution
• DO NOT connect any speaker wires to the metal body or
chassis of the vehicle.
• DO NOT connect the speaker common (-) wires to each
other.
• Connect each speaker wire directly to each speaker termi-
nal.
• All speaker common (-) wires must remain floating.
ie. No common connections or connection to vehicle grd.
• Connect each pair of speaker leads only to a single speaker
(or speaker system) that has an impedance of least 4 ohms,
as well as adequate power-handling capability.
• Do not connect speaker leads to any inputs on external
amplifiers. This will cause damage to the internal amplifier
of this unit.
1
Make sure the car's ignition key has been removed.
2
Disconnect the negative(-) terminal of the car's bat-
tery.
3
Connect the car's antenna terminal to the antenna
socket of the unit.
4
Connect the Car-specific adapter cable which is avail-
able at your dealer to the unit.
5
Reconnect the negative(-) terminal of the car's bat-
tery.
6
Start the car's engine.
7
Make sure the unit operates properly.
C-1 C-2 C-3
1 4 7 10 13 16 19
C
3 6 9 12 15 18
2 5 8 11 14 17 20
B 1 3 5 7
2 4 6 8
7
1 3 5
A
2 4 6 8
A B
1 NC 1 Speaker out RR+
2
2 Telephone mute Speaker out RR–
NC 3
3 Speaker out RF+
Permanent +12V 4 Speaker out RF–
4
5 Aut. antenna 5 Speaker out LF+
NC 6
6 Speaker out LF–
Kl.15/Ignition 7 Speaker out LR+
7
Ground 8 Speaker out LR–
8
C
C-2
C-1
1 Line Out LR 7 NC
2 Line Out RR NC
8
3 Line Out Masse/GND 9 NC
4 NC
NC 10
5 NC 11 NC
6 +12V Amplifire 12 NC
Equalizer
or
Amplifier
C-3
13 CDC Data In
CDC Data Out
14
15 NC
+12V
16
17 Bus Masse/GND
Line In Masse/Ground
18
19 Line In L
20 Line In R
CD Changer
or
Auxiliary equipment
E-9