Operation
Figure 5
A
B
Electric Fireplace Manual
Controls (Figure 5)
The manual controls for the
fireplace are behind the access
panel located at the bottom of the
fireplace.
A. Three Position On/Off
Switch
The switch has two (2) on
positions marked with " I " and
" II ". The " I " position is for
manual operation. In this position
the built-in remote control is
bypassed. The " II " position is
for operating the unit with the
provided remote control. When in
" II " position the unit is operated
with the ON and OFF buttons
of the remote control. When
the switch is in the center " O "
position the unit is off.
B. Flame Action Control
Turn the Flame Action Control
knob to adjust the flame speed to
the desired level.
C
C. Light Dimmer Control
Turn the Light Dimmer Control
knob to increase or decrease the
brightness of the interior of the
fireplace.
D. Heater On/Off Switch
The Heater on/off switch
supplies power to the heating
unit when the Three Position on/
off switch (A) is on
positions).
E. Heater Thermostat Control
To adjust the temperature to
your individual requirements,
turn the thermostat control
clockwise all the way to turn
on the heater. When the room
reaches the desired temperature,
turn the thermostat knob counter
clockwise until you hear a click.
Leave in this position to maintain
the room temperature at its
setting. For additional heat, turn
clockwise until you hear the click
again and the heater will turn on.
D
E
(" I " or " II "
11