Instructions For Use; Color Temperature - Zafferano Pencil Serie Instrucciones De Uso

4. Tips for use:
This product is exclusively for lighting purposes and:
A) It must not be exposed to heavy mechanical loads or contamination; B) It can be installed and used only after checking the state of the
product; check that is not dirty and has not been damaged during storage; C) Installation and maintenance must be carried out when the ap-
pliance is switched off; D) Any alterations to the product, any tampering and any failure to comply with the instructions provided may make the
appliance hazardous; E) Products with IP65 protection are suitable for outdoor use; F) All metal and plastic surfaces should be cleaned with
a soft dry cloth; G) The company Zafferano shall not be held liable for any damage caused due to its products being assembled in any manner
that does not comply with the instructions provided.
5. Important!
- The support surface for the lamp must not exceed a 15° tilt or it will fall.
- The battery is provided with the following protection functions: short circuit, over discharge, over charge, over current, over voltage.
- To preserve the integrity of the battery, we recommend keeping the charge between minimum 20% and maximum 80%; if the lamp is not used
for long periods, it is advisable to regularly charge/discharge the product.
- Please refer to local laws for the proper disposal and recycling of the battery.
0 - 5 sec 5 - 10 sec
2700K 3350K

INSTRUCTIONS FOR USE

Switching on / dimming / switching off
0 - 1 sec ON
100%
0%
OFF
6%
30%
2 sec
OFF

COLOR TEMPERATURE

10 - 15 sec
4000K
For more information and updates visit our website
DESIGNED BY ZAFFERANO SRL IN ITALY, MADE IN PRC.
Zafferano srl, Viale dell'Industria, 26 - 31055 Quinto di Treviso - TV - Italy
www.zafferanoitalia.com
Quick taps to:
- turn on
- change the brightness
60%
- turn off the lamp
The steps are repeated in a cycle.
When you press and hold the touch button for two se-
conds, the lamp turns off, memorising the current dimmer
setting and proposing it again the next time the lamp is
turned on.
When the lamp is turned off, press and hold the touch
button:
- after 5 seconds it turns on at 2700K
- after 10 seconds it switches to 3350K
- after 15 seconds it switches to 4000K
The steps are repeated in a cycle.
If you release your touch during one of the steps, the lamp
memorises the setting of the current step.
5