Direct Tuning - Aiwa AV-X100 Manual De Instrucciones

DIRECT TUNING
1
2
MONO
TUNER
Press the TUNER button repeatedly to select the
desired band.
~
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press the UPA or DOWNY button to select a
~tati~nm
E:ach time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed for two
seconds. During FM stereo reception, (I(O)])
k
displayed.
To search for a station quickly (Auto Search)
Keep the UPA or DOWNV button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the UPA or DOWNY
button.
o
The Auto Search may not stop at stations with very weak
sifgnals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
"MCINO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the butkm so that MONO
disappears.
1,2 3
DOWN~, UPA
I
I I
When you know the frequency of the desired station, you can
tune in directly to the station.
1
2
3
Press the TUNER button to select a band.
Press the TUNER button and hold it down until
" " flashes on the display (Direct Tuning Mode).
—
Press the appropriate numeric buttons to tune
in to the desired station.
Example:
To tune in to 106.50 MHz, Dress 1, 0, 6, 5 and O buttons.
To tune in to 95.25 MHz, p;ess 9, 5, 2 and 5 buttons.
To
cancel
the Direct tuning mode
Press the UPA or DOWNY button.
When entering a frequency out of tuning range, the value
flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.
When entering a frequency not covered by the tuning interval,
the value is automatically rounded up or down to the closest
one covered by it.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Hold down the TUNER button and press the POWER button
~?ediatelv. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for about two
seconds.
To reset the interval, repeat this procedure.
ENGLISH
10