Starting Operation - Bosch IXO Manual Original

OBJ_DOKU-28030-004.fm Page 33 Wednesday, August 6, 2014 10:12 AM
Eccentric Driver Head/Angle Driver Head/Torque Attachment
(see figures C – F)
The eccentric driver head 13 enables screwdriving close to edges.
The angle driver head 14 enables screwdriving at hard to reach locations.
With the torque presetting ring 16 on the torque attachment 15, the request-
ed torque can be preset in 10 steps. With the correct setting, the tool bit is
stopped as soon as the screw is driven flush into the material or when the set
torque is reached.
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap 3 off toward the front.
Afterwards the attachments can be mounted. The attachments can be
mounted offset by 45°.
Dismounting (see figures E–F)
To dismount the attachments, turn the release ring 18 in rotation direction
 and pull the attachment off toward the front. Afterwards, mount the rub-
ber cap 3 again.
Operation

Starting Operation

 Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Bat-
tery chargers marked with 230 V can also be operated with 220 V.
Reversing the rotational direction
The rotational direction switch 9 is used to reverse the rotational direction of
the machine. However, this is not possible with the On/Off switch 8 actuated.
Right rotation: For driving in screws, push the rotational direction switch 9
left to the stop.
The indicator for right rotation 4 lights up when the On/Off switch 8
is actuated and the motor is running.
Left Rotation: For loosening or unscrewing screws, push the rotational
direction switch 9 right to the stop.
Bosch Power Tools
English | 33
1 609 92A 0P3 | (6.8.14)