Using The First-Time Setup; Initial Setup - HP LC3260N Guía De Usuario

sa6ldtv.book Page 19 Tuesday, February 21, 2006 12:35 PM

Initial Setup

When turning on the TV for the first time, an initial
setup walks you through the following:
Setting the onscreen display language.
■
Setting the clock time.
■
Selecting the signal source (antenna or cable)
■
Automatically searching for and memorizing the
■
available channels.
If the TV has been turned on before, the initial setup
does not start. In this case, use the onscreen display
(OSD) menus to set the language and scan for
channels; refer to "Changing the TV Settings" on
page 27.
Preparing
Perform the following steps before you press TV Power
on the remote control unit.
1
Insert the batteries into the remote control unit.
2
Connect the antenna cable to the TV.
3
Plug in the AC cord to the AC outlet.
Turning on the TV
Press the power button on the TV or on the remote
control; refer to "Turning On the TV" on page 17.
Language setting
Press the arrow buttons on the remote control to select
the desired screen language. Select from among three
languages: English, French, and Spanish.

Using the First-Time Setup

Clock setting
1
Press the arrow buttons on the remote control to
select Clock Set, and then press the right arrow
button. The Clock Set menu screen appears.
2
Press the left or right arrow buttons to set the
Month entry, and then press the down arrow
button to move to the next item.
3
Repeat step 2 to set each of the Day, Year, and
Time (hour and minutes) entries.
4
Press OK.
Antenna setting
Select the type of TV input source you connected to the
Ant/Cable connector.
1
Press the arrow buttons to select Air/Cable, and
then press the right arrow button.
2
Press the left arrow or right arrow buttons to select
Air (antenna) or Cable.
Using the First-Time Setup
19