Carson X-24 Manual De Instrucciones página 17

Steering trim (ST. TRIM)
Rotate the trim to adjust the steering servo in the neutral position of
the steering wheel.
To fit the steering servo:
1. Set the steering angle regulator to maximum. Then fit the servo
into the model so that the steering mechanism operates at maxi-
mum.
2. If the geometric design does not allow the steering to be fully
turned you should reduce the steering angle slightly. This can also
be useful for courses that only have wide curves.
Throttle trim
The throttle trim (TH.TRIM) is used to adjust the neutral position of the
throttle when the throttle trigger is released, idle with a combustion
engine, engine „off" with an electric motor.
Charging jack
Note:
ON/OFF Switch should be at „OFF" position before charging
the batteries for the transmitter. Only Nickel-Cadmium or
Nickel-Metalhydride batteries (Ni-Cd/NiMH), such as CARSON 2x
N° 500 005 4010 or its equivalents, are to be recharged. If you attempt
to recharge other types of batteries, they may burst and cause injury
or damage to you and others.
Do not recharge other types of batteries, such as alkaline!
Charging jack
Polarity of charging jack
Steering trim
channel 1
Throttle trim
channel 2
Steering rate adjuster
Steering rate adjuster
Strokes of the steering servo horn can be adjusted by rotating this
steering rate adjuster, in the range from 10% to 100%.
The controller can be rotated round 300°. The deflection gets greater
when the controller is turned to the right and smaller when the
controller is turned to the left.
CARSON X-24 17
GB GB