Care & Maintenance; Cleaning; Storing; Resetting The Motor Thermostat - Ninja chef CT810 Manual De Instrucciones

CARE &
MAINTENANCE

CLEANING

1
Separate all parts.
2 Hand-Washing
Wash containers, blade assemblies, lids,
and tamper in warm, soapy water, using a
dishwashing utensil with a handle to avoid
direct contact with the blades. Exercise
care when washing Pro-Extractor Blades
Assembly and pitcher, as the blade
assemblies are sharp. Thoroughly rinse and
air-dry all parts.
Dishwasher
The tamper and all containers, lids, and
blade assemblies are dishwasher safe. It is
recommended that the tamper and lids be
placed on the top rack of the dishwasher.
Exercise care when handling pitcher and
Pro Extractor Blades assembly, as the blade
assemblies are sharp.
Using Clean Mode
To run the self-cleaning program with
the pitcher, first add warm water to the
MAX CLEAN line and a couple drops of
dishwashing soap to the pitcher. Secure
the pitcher lid and lid cap in place. Select
CLEAN mode, then press START/STOP to
begin. The unit will shut down when the self-
cleaning cycle is complete. Make sure to
thoroughly rinse and air-dry the pitcher.
When using CLEAN mode for the blender
cup, fill the cup halfway with warm water
and add one drop of dishwashing soap.
Motor Base
Turn off the unit and unplug the motor base
before cleaning. Wipe motor base with a
clean, damp cloth.
Clean the control panel with a soft cloth,
such as microfiber, to prevent scratching. To
remove residue from the control panel, you
may use an all-purpose cleaner.
19
1-877-646-5288
NEVER directly spray the base or control
panel with water or other liquids.
DO NOT use abrasive cloths/pads/brushes
to clean the base or control panel, as this
can dull or scratch the surface.

STORING

Store the unit upright with the lid on the pitcher.
®
DO NOT store blended or unblended
ingredients in the Single-Serve Cup with the Pro
Extractor Blades assembly attached.
DO NOT stack items on top of the containers.
Store any remaining attachments alongside
the unit or in a cabinet where they will not be
damaged or create a hazard.

RESETTING THE MOTOR THERMOSTAT

This unit features a unique safety system
that prevents damage to the motor and drive
system should you inadvertently overload the
unit. If the unit is overloaded, the motor will be
temporarily disabled, and the control panel will
not function when modes are pressed. Should
this occur, follow the reset procedure below.
1
Unplug the unit from the electrical outlet.
2 Allow the unit to cool for approximately 15
minutes.
3 Remove the pitcher lid. Empty the pitcher
and ensure no ingredients are jamming the
blade assembly.
4 Return the pitcher to the motor base.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
If your unit needs servicing, please call
Customer Service at 1-877-646-5288.

ORDERING REPLACEMENT PARTS

To order additional parts and attachments,
please visit ninjaaccessories.com or contact
Customer Service at 1-877-646-5288.