Technical Data; Safety Regulations - EINHELL SS 1500 Instrucciones De Manejo

Anleitung SS 1500
Important:
Please read the instructions carefully before
assembling and using for the first time!

Technical data

Materials:
Length of profiled rail:
Carriage travel:
Carriage table size:
Carriage bearings:
Table height: 850 mm, same as machine height
Max. load:
Total weight:
Description
The Einhell sliding carriage is an accessory item
intended specially for the Einhell PKS 250 W/D
precision circular saw. It can be used to cut panel
materials of all types and is particularly ideal for
cutting exact angles and dimensions. The carriage
runs on four steel ball bearings. It is imperative to
Assembly
The numbers used in the drawings correspond to the serial numbers in the list of replacement parts.
1
Fit the two fixing brackets (1) with the oval head
screws (12) and the washers (13) to the machine as
shown using hand force only.
09.11.2001 10:38 Uhr
aluminium sections,
steel plate fasteners
1500 mm
1180 mm
500 mm x 290 mm
4 ball bearings
50 kg
27 kg
Seite 5
follow the operating instructions. The manufacturer
shall not be liable in any way for damage arising from
modifications made to the machine.

Safety regulations

Observe the safety regulations for your precision
circular saw
Follow the operating instructions for your precision
circular saw
Fit the Einhell sliding carriage only on Einhell
precision circular saws
Fit the sliding carriage in accordance with the
assembly instructions
Do not exceed the maximum table load quoted in
the technical data
Keep your workplace clean at all times
The manufacturer shall not be liable for any
damage resulting from unauthorized modifications
to the sliding carriage
Check that the sliding carriage is in good working
order before switching on the machine
Protect from the wet and damp
Allow only instructed persons to work with the
sliding carriage
The accident prevention regulations in force in
your country are to be strictly observed
Follow the safety regulations issued by the
professional associations in your country
2
Screw the two guide shafts (4) to the profiled rail (3)
with the six M5x10 oval head screws and the M5 nuts
(9). Then tighten securely.
GB
5