Risk Of Electrocution; Burner Fuel Tank - power washers HPW-1500E Manual Del Operador

INSTALLATION & PREPARATION
POWER CORD CONNECTION CONT'D.:
5. b. SINGLE PHASE: If this pressure washer is not provided with a
GFCI, this pressure washer should only be connected to a
receptacle that is protected by a Ground Fault Circuit Interrupter
(GFCI) to comply with the National Electric Code (NFPA 70) and
to provide additional protection from the risk of electric shock.
c. THREE PHASE: These pressure washers are not provided
with GFCI protection.
6. EXTENSION CORDS:
RECOMMEND THE USE OF EXTENSION CORDS!
extension cord is unavoidable, it must be plugged into a GFCI found in
circuit boxes or protected receptacles. When using an extension cord,
consult a qualified electrician to determine the proper wire gauge needed
for the length of the extension cord.
SINGLE PHASE: Use only 3-wire extension cords that have 3-prong
grounding-type plugs and 3-pole cord connectors that accept the plug
from the product.
THREE PHASE: Use only 4 wire extension cords that have 4-prong
grounding type plugs and 4-pole cord connectors that accept the plug
from the product.
Use only extension cords that are intended for outdoor use. These
extension cords are identified by a marking "Acceptable for use with
outdoor appliances; store indoors while not in use." Use only extension
cords having an electrical rating not less than the rating of the product.
Do not use damaged extension cords. Examine extension cord before
using and replace if damaged. Do not abuse extension cord and do not
yank on any cord to disconnect. Keep cord away from heat and sharp
edges. Always connect and disconnect the extension cord from the
receptacle before connecting and disconnecting the product from the
extension cord.
7. Ensure the area between the pressure washer cord and outlet is kept
dry.
8. Insert the male plug into a grounded AC outlet. DO NOT use an adapter

BURNER FUEL TANK:

1. Review "Risk of Explosion or Fire" pg. 5, before fueling.
2. Locate the Safety Decals on your unit and heed their warnings.
3. Fill the burner fuel tank with good quality, clean No. 1 or No. 2 fuel oil
diesel or kerosene. Do not use gasoline!
Operator's Manual
THE MANUFACTURER DOES NOT
If use of an

RISK OF ELECTROCUTION!

TO R E D U C E T H E R I S K O F
ELECTROCUTION, KEEP ALL
CONNECTIONS DRY AND OFF THE
GROUND. DO NOT TOUCH PLUG
WITH WET HANDS.
-DO NOT SMOKE WHILE FUELING!
-DO NOT FILL THE FUEL TANK WHILE
UNIT IS RUNNING OR HOT. ALLOW
UNIT TO COOL FOR TWO MINUTES
BEFORE RE-FUELING.
-DO NOT FILL FUEL TANK TO
POINT OF OVERFLOWING. ALLOW
APPROXIMATELY 1/4" OF TANK
SPACE FOR FUEL EXPANSION.
RISK OF EXPLOSION OR FIRE!
ALWAYS STORE FUEL AWAY FROM
THE WASHER WHILE THE UNIT IS
RUNNING OR HOT.
WARNING
DANGER
RISK OF FIRE!
WARNING
11