Snapper SPX 150 Serie Manual Del Usuario página 22

Servicing the Air Filter
WARNING
Fuel and its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.
• Never start or run the engine with the air cleaner
assembly or air filter removed.
NOTICE: Do not use pressurized air or solvents to clean the
filter. Pressurized air can damage the filter and solvents will
dissolve the filter.
1. Remove the fasteners (A, Figure 11) and the air filter
cover (B).
2. To remove the filter (C), lift the end of the filter and then
pull the filter off the intake (D).
3. Remove the pre-cleaner (E), if equipped, from the filter.
4. To loosen debris, gently tap the filter on a hard surface. If
the filter is excessively dirty, replace with a new filter.
5. Wash the pre-cleaner in liquid detergent and water.
Then allow it to thoroughly air dry. Do not oil the pre-
cleaner.
B
A
C
6. Assemble the dry pre-cleaner to the filter.
7. Install the filter on the intake. Push the end of the filter
into the base as shown. Make sure filter fits securely in
the base.
8. Install air filter cover and secure with fasteners.
NOTE: Replace pre-cleaner/cartridge when dirty or
damaged.
22
Pre-Cleaner Cleaning
1. Wash in soapy water with liquid detergent.
2. Squeeze dry in clean cloth.
Cartridge Cleaning
Tap gently on flat surface to remove light debris. Do not
attempt to clean cartridge.
Servicing the muffler
WARNING
Running engine produces heat. Engine parts,
especially muffler, become extremely hot.
Severe thermal burns can occur on contact.
Combustible debris, such as leaves, grass, brush,
etc. can catch fire.
• Allow muffler, engine cylinder and fins to cool before
touching.
• Remove visible debris from engine compartment.
WARNING
Replacement parts must be the same position as
the original parts or fire could result.
To service the muffler, see an authorized dealer.
D
E
Figure 11