Manual Mode - Heath Zenith DualBrite 4167 Instrucciones De Instalación Y Funcionamiento

4. Adjust the SENSITIVITY to increase or
decrease the range as needed. Too much sen-
sitivity may cause false triggering due to heat
sources in the coverage area (see Adjustment
of Coverage Area or Troubleshooting section).
5. Set the amount of ON-TIME you want the
light to stay on after motion is detected (1, 5,
or 10 minutes).
6. Set the DualBrite® switch to off, 3 hours, 6
hours, or dusk-to-dawn.
6 ft.
(1.8 m)
30 ft.
(9.1 m)
Maximum Range
The sensor is less sensitive to motion directly
towards it and more sensitive to motion across
coverage area.
Motion
Least Sensitive
Maximum
Coverage Angle*
(Top View)
Motion
Sensor
Most Sensitive
Mode:
Test 5 Seconds
Auto
Accent
To Dawn*
Manual
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
for the circuitry to calibrate.
180°
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
6
OPERATION
On-Time Works: Day Night
1, 5, or 10
Minutes
3, 6 Hour,
To Dawn

MANUAL MODE

x x
x
x
x
/ minutes
1
2
1 Second
OFF then...
... back on.
200471-02