Preparations For Mounting - Okoru Global MasterSun MAXIM Manual De Instrucciones

A minimum of two adults are required to move and install the awning as
the product is big and heavy. Do not try to install the awning alone. If the awning falls, it
could cause serious injuries and damages!
Keep children and pets out of the working area during assembly and
adjustments.
This product and its spare parts are only suitable for installation on a plain
cement wall or stable brickwork. If the wall/brickwork shows cracks you have to
consult a professional.
If your building has an exterior shell (such as insulation, double brick wall, brick
facing), installation should be taken out by a professional.
Any change in the design and structure of the awning without the permission of the
distributor will be at your own risk.
Please make sure that your hands are clean at the time of the assembly; otherwise you
may soil the awning fabric and frame.
In case of rain retract the awning if tilt angle is less than 14°.
Climbing and hanging anything on the awning is forbidden.
When extended, various forces, including wind and rain, will affect an awning.
Therefore avoid mounting it in these conditions and pick it up when this happens
Carefully remove the awning from the box and remove the styrofoam protectors
from the awning.
Remove the plastic bags and plastic guards from the awning and carefully place
the awning aside to avoid having it damaged by scratches or otherwise
damaged or soiled during assembly.
Check the number of parts in the packaging whether the packing list
requirements, the quality of parts availability issues, if questions, please contact
the supplier.
Be aware the sudden extension may occur during unpacking.
Tools needed for assembly:
• Drill
• Masonry drill bit, 14 mm
• Level
• Wrench 14 mm, 17 mm and 19 mm
• Stepladder
• Tape measure
• Chalk or marker pen
• Wooden hammer

Preparations for mounting

Step 1: Chose Mounting Location
The awnings must be installed at least at the height of 2.5 m
Ensure that you also take this drop height into account in your decision on
where to install the awning. The drop angle can still be changed after assembly.
The ideal drop angle, however, has already been set at the factory and may
only be changed minimally.