Jumpstarter; Jump Starti Ng - Absaar AB210-100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
Insert the cigarette lighter plug of the 12V DC/DC adapter/charger (No.7, see figure 1) into an
12V DC cigarette lighter receptacle (on your vehicle or boat) and put the other (output) end into
the receptacle (beside DC charging LED No.10, see figure 1) on the front panel of your power
booster until the battery meter shows full (14 to 15V DC)
To use your

JUMPSTARTER

3.
Life up the cover of 12V DC cigarette lighter receptacle (see No.1 of figure 1)
4.
Insert the 12V DC cigarette lighter plug from the appliance into the 12V DC cigarette
lighter receptacle on the side of your booster
The following table will give you an idea of what operation time you can expect when starting
from a fully charged system.
Appliance type
Fluorescent lights cell phones
Radios, fans ,depth finders
Camcorders ,VCR's spotlights
Electric tools ,bilge pumps
Electric coolers
Air compressors ,car vacuums
For performance when using your power booster to jump start a vehicle or boat, please read and
follow these step by step instructions:
6.
Connect the red (+) alligator clamp to the red (+) positive battery terminal or the vehicle or
boat.
7.
Connect the black (-) alligator clamp to a non-moving metal part of the engine, NOT to the
(-) negative battery terminal.
8.
Wait a minute or two
9.
Turn on the Power Switch then switch the vehicle or boat engine ignition to "start" for no
more than 5 to 6 seconds.
10. If the vehicle or boat engine does not start, wait at least 3-minutes before trying again.
Under no circumstances allow the red and black clamps to touch each other or a common
contact
1.
Once the engine is running , disconnect the black(-)clamp first and return this cable to its
stored position on the power booster.
2.
Disconnect the red (+) clamp and return this cable to its stored position on the power
booster.
3.
As soon as possible connect your power booster system to the AC adapter. charge and
recharge.
OPERATION
as a 12V DC/DC power source:
Estimated power consumption
(in watts )
4
9
15
24
48
80

JUMP STARTI NG

Emergency light-bulb replacement.
12
Estimated usage time
(in hours )
30
21
12
7
3
1.5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ab215-100

Tabla de contenido