Continental Electric CE23191 Manual De Instrucciones página 4

GENERAL INSTRUCTIONS
When using the iron for the first time, you may notice a slight emission of smoke and
hear some sounds made by the expanding plastics. This is quite normal and it stops
after a short time. We also recommend passing the iron over an ordinary cloth before
using it for the first time.
PREPARATIONS
Soft the laundry to be ironed according to the international symbols on the garment
label, or if this is missing, according to the type of fabric.
GARMENT LABEL
•
••
•••
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down)
and eliminates the risk of scorching the fabric.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight
minutes in the upright position or unused for approx. Thirty seconds in the horizontal
position. The light comes on to indicate that shut off has tripped. As soon as you move
the iron, the device turns off and the iron starts working again.
STEAM IRONING
Filling the reservoir
- Check that the plug is disconnected from the socket.
- Move the steam selector (3) to "0" [Fig. 1].
- Open the lid (2).
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the reservoir using the special measure (14) and tak-
ing care not to go over the maximum level (about 300ml) indicated by "MAX" on the
reservoir [Fig. 2].
- Close the lid (2).
FABRIC TYPE
synthetic
silk - wool
Cotton - linen
THERMOSTAT REGULATION
low temperature
medium temperature
high temperature
Fabric not to be ironed