Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SO-309001_16173 Rival Iron WM USA IM_Layout 1 12-04-11 11:37 AM Page 7
SPRAY MIST
Use the Spray Mist to dampen dry, difficult fabrics, to remove wrinkles and to set
creases. The spray mist can be used while either dry or steam pressing.
1.
Make sure there is adequate water in the water tank. See Filling the Water Tank
section for specific operating instructions.
CAUTION: IF THE IRON IS HOT, DO NOT ADD WATER.
2.
Firmly press the spray mist button. (See Figure 7.) It may be necessary to press
the button 2 to 3 times successively to release the initial spray of water.
Figure 7
NOTE: Spray misting can be used on any heat setting and does not affect
the ironing temperature.
CAUTION HOT SURFACES: Avoid coming in contact with escaping steam.
USER MAINTENANCE INSTRUCTIONS
This appliance requires little maintenance. It contains no user serviceable parts.
Do not try to repair it yourself. Contact a qualified appliance repair technician
if the product requires servicing.
EMPTYING THE WATER TANK
IMPORTANT: The water tank should be emptied after each use.
1.
Unplug the power-supply cord from the electrical outlet.
2.
Empty the water tank by turning the soleplate away from you; then carefully
turn the Iron upside down over a sink. Allow any remaining moisture inside
the Iron to evaporate before storing.
CAUTION: Even if the soleplate is cool, use caution when draining water
from the water tank as the water may still be hot.
CARE & CLEANING INSTRUCTIONS
CAUTION: Unplug the power-supply cord from the electrical outlet before cleaning
the exterior of the Iron and storing. Never immerse the cord, plug or Iron in water
or any other liquid.
1.
To remove or clean starch or other materials from the ironing surface
of the soleplate, apply a small amount of mild, non-abrasive cleaner
to a water-dampened cloth to form a paste on the cloth.
2.
Gently rub paste onto the cooled soleplate and wipe it clean with a moist cloth.
WARNING: Never use scouring pads, abrasive, or harsh cleaners as these
will scratch the soleplate.
WARNING: Never add any chemical cleaning agents or solvents to the water
tank.
STORING INSTRUCTIONS
IMPORTANT! Allow the Iron to COOL COMPLETELY before storing.
1.
Empty the water tank after each use.
2.
Wrap cord loosely around the cooled Iron when storing.
3.
To protect the soleplate, place the Iron in an upright position on its heel.
7
Publicidad
Tabla de contenido
