Use Instructions And Limitations; Use For - Macurco CX-6 Instrucciones De Uso

Macurco CX-xx Manual (Rev-1.0) Eng
and service the internal circuits. Ensure power is de-energized from the detector relays
prior to servicing the unit. Failure to do so may result in electrical shock.
Do not disassemble unit or attempt to repair or modify any component of this
instrument. This instrument contains no user serviceable parts, and substitution of
components may impair product performance.
Using a certified gas with a concentration other than the one listed for this detector
when conducting a calibration verification test (bump test) will produce inaccurate
readings. This means that higher levels of the gas being monitored may be present and
could result in overexposure. For proper use, see supervisor or User manual, or
contact Technical Support at 1-844-325-3050.
The following steps must be performed when conducting a calibration verification test
(bump test) to ensure proper performance of the monitor. Failure to do so may
adversely affect product performance.
• When performing a calibration verification test (bump test) only use certified
calibration gas at the required concentration level.
Do not test with expired calibration gas.
•
Do not cover or obstruct display or visual alarm cover.
•
• Ensure sensor inlets are unobstructed and are free of debris
Failure to follow instructions outlined in this user manual can result in sickness or
death.

2 Use Instructions and Limitations

Each person using this equipment must read and understand the information in this
user manual before use. Use of this equipment by untrained or unqualified persons or
use that is not in accordance with this user manual, may adversely affect product
performance.

2.1 Use For

The CX-xx provides CO and NO
enclosed parking garages, utility rooms, warehouses and other commercial applications where the potential for
Carbon Monoxide and/or Nitrogen Dioxide gas exists. The CX-xx meets the requirements of the Uniform Building
Code for enclosed garages and meets OSHA standards for CO and NO
with the Macurco DVP-120 Detection and Ventilation Control Panel, other 12 VAC or 24 VDC fire/security panels or
building automation systems.
Use only for monitoring the gas which the sensor and monitor is designed to detect.
Failure to do so may result in exposures to gases not detectable and cause serious
injury or death. For proper use, see supervisor or user manual, or contact Technical
Support at 1-844-325-3050.
REV – 1.1
WARNING
detection and automatic exhaust fan control for automotive maintenance facilities,
2
WARNING
[34-2900-0512-0 ]
exposure. The CX-xx can be used stand alone,
2
5 | P a g e