Krups XP2280 Manual De Instrucciones página 16

Ocultar thumbs Ver también para XP2280:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KR_XP2280_NAFTA_NC00026071-01 17/11/11 17:55 Page13
English
Problems
The water tank leaks
when it is moved.
Water leaks under
the appliance.
Water leaks under
the drip tray
Crackles are heard
in the filter holder.
The pump is
abnormally noisy or
Espresso
the
LED and the
pictograms
,
,
flash.
The cups are not
filled equally.
Lots of water on the
ground coffee, in the
filter holder.
The espresso leaks
on the sides of the
filter holder.
Your espresso
tastes bad.
Your espresso has
no cream (froth).
13
Possible causes
The valve at the bottom of
the tank is dirty or defective.
The valve is blocked by
scale.
Internal leak.
Water can be present
and/or flow when you
remove the drip tray.This is
not a sign of a leak.
Normal phenomenon:
the filter holder security
lock.
No water in the tank.
Tank poorly fitted.
The Claris cartridge is not
filled with water.
The filter holder is clogged. Clean the filter holder (see paragraph 4).
Coffee insufficiently tamped
down.
Insufficient amount of
coffee.
The filter holder has not
been properly positioned.
The edge of the filter holder
is clogged by ground
coffee.
Pod poorly positioned in the
filter.
The brewing head seal is
dirty.
The brewing head seal is
defective.
After descaling, the rinsing
was not performed properly.
Coffee grounds too coarse,
stale or too dirty.
Solutions
Wash the water tank and operate the valve at the
bottom of the tank with your finger.
Descale the appliance (paragraph 5).
Check the position of the tank. If the fault persists,
do not use the appliance, contact an approved
service centre.
Stop the appliance, fill the water tank and turn
the machine back on.
Press down firmly on the tank.
Please refer to paragraph 1.
Tighten the filter holder as far as it will go, up to
the stop (fig.7).
Add more espresso ground coffee.
Put the filter holder in place and lock it (by
turning it to the right as far as it will go, up to the
stop).
Remove excess coffee.
Place all the paper inside the filter holder.
Clean the seal with a damp cloth.
Contact a Krups approved service centre.
Rinse the appliance according to the manual
(see paragraph 5).
Try fresher or finer espresso coffee grounds.

Publicidad

Tabla de contenido
loading

Tabla de contenido