Safety Information; Preliminary; During Use; Symbols - koban KPA 03 Manual Del Usuario

Safety information

The meter is completely portable,
LCD, 3 1/2 digit clamp meter with
insulation test function (with option
500V insulation tester unit).
It has been designed according to
IEC1010-1 IEC1010-2-032 concerning
electronic measuring instruments
with an overvoltage category (CAT II
1000V & CAT III 600V) and pollution
2 and safety requirements for hand-
held current clamps for electrical
measurement and test.
Follow all safety and operating
instructions to ensure that the meter
is used safely and is kept in good
operating condition. For warranty
service, you must present this receipt
with the purchase receipt or invoice.

Preliminary

When using this meter, the user
must observe all normal safety rules
concerning:
• Protection against the dangers
of electronic current.
• Protection of the meter against
misuse.
• Full compliance with safety
standards can be guaranteed
only if used with test leads
supplied. If necessary, they
must be replaced with the same
model or same electronic
www.grupotemper.com
Digital clamp multimeter

During Use

Never exceed the protection limit
values indicated in specifications for
each range of measurement.
When the meter is linked to
measurement circuit, do not touch
unused terminals.
When the value scale to be
measured is unknown beforehand,
set the range selector at the highest
position. Before rotating the
range selector to change function,
disconnect test leads from the circuit
under test.
When carrying out measurements on
TV or switching power circuits always
remember that there may be high
amplitude voltage pulses at test
points, which can damage the
meter. Never perform resistance
measurements on live circuits.
Always is careful when working with
voltage above 60V dc or 30V ac
rms. Keep fingers behind the probe
barriers while measuring.
Safety Symbols
Important safety information,
refer to the operating manual.
Dangerous voltage may be
present.
Instructions manual |
KPA 03
13