Installation - Frigidaire FRTS07G3HRW Manual De Instrucciones

Installation

Space requirement
Select a location without direct exposure
to the sunlight;
Select a location with enough space for
the refrigerator doors to open easily;
Selec a location with level (or nearly
level) flooring;
Allow sufficient space to install the
refrigerator on a flat surface;
Allow clearance to the right, left, back
and top when installing. This will help
reduce power comsumption and keep
you energy bills lower.
Leveling and anchor the refrigerator
Leveling and anchor the refrigerator by
adjusting the feet.
Clockwise rotate feet to heighten them
by hand.
Anticlockwise rotate feet to lower them
by hand.
Service
Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
This product must be serviced by an
authorized Service Center, and only
genuine spare parts must be used.
Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
21
1120 mm
135
1195 mm
Climate class Ambient temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
Location
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely
around the back of the cabinet. To
ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the cabinet
and the wall unit must be at least 100
mm. Ideally, however, the appliance
should not be positioned below
overhanging wall units. Accurate leveling
is ensured by one or more adjustable
feet at the base of the cabinet.
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply. The appliance
must be earthed. The power supply
cable plug is provided with a contact for
this purpose. If the domestic power
supply socket is not earthed, connect
the appliance to a separate earth in
compliance with current regulations,
consulting a qualified electrician. The
manufacturer declines all responsibility if
the above safety precautions are not
observed. This appliance complies with
the E.E.C. Directives.
22