Atlantic SOLCC2 Manual De Operación página 3

• When camouflaging the light cord with rocks and gravel, always leave enough
slack in the cord so that the fixture can be raised above water level for servicing.
• Always verify that the lens cover is tightly secured before submersing the fixture.
• Never cut or shorten the light cord between the Control Module and the light
fixture. Altering the Light Cord will damage the LEDs and void warranty.
• 6 wire extension cords (part # SOLCCEXT) are available to add an additional
20' of cord to any SOL Color Changing Light. Only one cord can be used on
each light. Never connect multiple extension cords together.
SOLCCMX3 Control Module Installation
• The Control Module is weather resistant with an IP54 rating. Do not submerse
it or expose it to heavy rainfall. It must be mounted off the ground close to the
power source. Failure to do so will void the warranty.
• Ensure that all cable connections are secure.
• Install the control box in a well-ventilated area to ensure that the module
operates within its specified working temperature.
• Verify that the control module input voltage is 12 volt AC. We recommend that
you use the transformer provided with this unit.
• Do not connect the power before the cord connections are finished.
• Do not cut or alter the cord between the SOL Light and the Control Module.
• The remote control requires three (3) AAA batteries (not included).
Connecting the Lights
Follow the connecting chart below to connect all cables. The SOLCCMX3 Control
Module and 3-way splitter will accept any combination of Color Changing SOL Light
styles. If more lights are required, multiple splitters can be connected together to
create more outlet connections. A larger transformer (80 watts
maximum) is required if additional lights are installed.
Transformer Control Module
3-way
Splitter
SOLCC6
SOLCCLR
SOLCC2
3