Publicidad
Idiomas disponibles
Idiomas disponibles
1
/
"
1
4
Screw
Short Wood
Block
Dimplex
Header
Figure 5 - attaching Blocks to Dimplex Header
1
1
/
" Screw
4
Short Wood
Block
Dimplex
Kit Header
Figure 6 - mantel Kit Installation for Dimplex
ATTAchING TOP OF mANTEl
1. Place top onto mantel (see Figure 7). The rear of legs
should be flush with back of mantel top and centered left
to right (see Figure 7).
2. Make sure mantel is centered left to right inside top and
rear of legs are flush with back of top. Gap between mantel
top and leg should be the same from front to back (see
Figure 8). Use 1
1
/
" screws through pocket holes in the
4
side assemblies and the front to attach top of mantel.
Leg
Assembly
Figure 7 - placing mantel top onto mantel assembly
119939-01A
Long Wood
Block
Mantel
Header
Long Wood
Block
Mantel
Top
Header
3. Attach supplemental brackets using 1/2" or 3/4" screws
provided in bracket hardware kit. Use 3 brackets to attach
top to mantel assembly - one at back of each leg assembly
and one at center of header (see Figure 8).
4. Place mantel base next to wall at installation location. See
fireplace owner's manual for installation clearances.
5. Place mantel assembly onto mantel base and center left
to right with the back flush with the back of the base (see
Figure 9).
6. Use 1
/
" screws in pocket holes to attach mantel assem-
1
4
bly to mantel base. Using brackets and 1/2" - 3/4" screws
from bracket hardware kit, attach support brackets to base
and mantel assembly - one at each back corner of the leg
sides and one on each leg front (see Figure 9).
Make certain
spacing is
the same
front and
back.
Figure 8 - attaching mantel top to Leg and Header assembly
1
/
"
1
4
Screws
1/2" or 3/4"
Screw
Bracket
Mantel Base
Figure 9 - attaching mantel assembly to mantel Base
www.desatech.com
Small Gap Between
Header and Top
Legs Should Be
Flush With Top
Bracket
1/2" or 3/4"
Screw
1
1
/
"
4
Screws
3
Publicidad
