Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER
Make sure tires are properly inflated to the
PSIshown on tires. Iftires are overor under
inflated,it may affectthe appearanceof your
lawn and lead you to think the moweris not
adjusted properly.
VISUAL
SIDE-TO-SIDE
ADJUSTMENT
1.
With all tires properly
inflated
and if your
lawn
appears
unevenly
cut,
determine
which
side of mower
is cutting
lower.
2.
With a 3/4" or adjustable
wrench,
turn lift
link adjustment
nut (A) to the left to lower
LH side of mower,
or, to the right to raise
LH side of mower.
NOTE:
Each full turn of adjustment
nut will
change
mower
height
about
3/16".
Turn nut rig
to raise mower
Turn nut left
to lower mower
,
Test your adjustment
by mowing some
uncut grass and visually
checking
the
appearance.
Readjust, if necessary, until
you are satisfied with the results.
PRECISION
SIDE-TO-SIDE
ADJUSTMENT
1.
With all tires properly
inflated,
park tractor
on level ground
or driveway.
CAUTION:
Blades
are
sharp.
Protect
your
hands
with gloves
and/or
wrap
blade
with heavy
cloth.
2.
Raise mower
to its highest
position.
3.
At both sides of mower,
position
blade at
side and measure
the distance
(A) from
bottom
edge of blade to the ground.
The
distance
should
be the same
on both
sides.
AI
;A
4.
If adjustment
is necessary,
see step 2 in
Visual
Adjustment
instructions
above.
5.
Recheck
measurements,
adjust if neces-
sary until both sides are equal.
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck
must
be level
side-
to-side.
To obtain
the best cutting
results, the mower
blades
should
be adjusted
so the front tip is
1/8" to 1/2" lower than the rear tip when the
_lbower is in its highest
position.
CAUTION:
Blades
are
sharp.
Protect
your
hands
with gloves
and/or
wrap
blade
with heavy cloth.
Raise
mower
to highest
position.
Position
any
blade
so the tip is pointing
straight
forward.
Measure
distance
(B)
to the ground
at front and rear tip of the
blade.
If front tip of blade is not 1/8" to 1/2" lower
than
the rear tip, go to the front
of trac-
tor.
• With
an
11/16"
or adjustable
wrench,
loosen
jam
nut A several
turns
to clear
adjustment
nut B.
• With a 3/4" or adjustable
wrench,
turn
front link adjustment
nut (B) clockwise
(tighten) to raise the front of mower, or,
counterclockwise
(loosen)
to lower the
front mower.
NOTE:
Each full turn of the adjustment
nut
will change mower height about 1/8".
Recheck measurements,
adjust if neces-
sary until front tip of blade is 1/8" to 1/2"
lower than the rear tip.
Hold adjustment nut in position with wrench
and tighten jam nut securely against ad-
justment nut.
Tighten adjust nut
B to raise mower
Loosen adjust
nut B to lower
mower
22
Loosen jam nut A first
Publicidad
