pei-POINT INVERTER AS25-13K Manual De Instruccion página 18

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

3.6.1
OPERATING GUIDE FOR AUTOBODY REPAIR WORKS
Double side gun electrode adjustment
Remove the compressed air supply
Close by hands the arms and adjust the electrodes so that they are perfectly aligned: a wrong aligning would reduce the
spot strength.
Sharpen the electrodes if necessary.
Replacing the arms
Press the large yellow clamp pushbutton to obtain the wide opening of the clamp
Turn off the compressed air supply
Switch off the machine
Place the clamp into the appropriate holder or at any rate at a position higher than the coolant liquid container
Slacken off the arm locking screws
Slip off the arms
Take the other arms and make sure that some grease is spread on the whole surface of the arm attachment
(recommended grease: Loctite 8065 C5-A copper anti seize)
Insert the arms fully into the mechanical stop
After having aligned the surfaces of the electrodes tighten the lock-screws.
Double side welding preparation
Clean both sides of the sheet metal on the area of the welding
spot to insure a good electric contact between the electrodes
and the metal sheets and between the sheets surfaces
Single side gun electrode sharpening
Sharpen the electrodes with a file
The electrode shape should be regular and not flat,
typically round or conic
Single side welding preparation
Clean both sides of the top metal sheet
Clean the top side of the bottom metal sheet
Clean the bottom metal sheet at the ground contact point
INVERTER AS25-13K AS25-15K "R3.2"
CLEAN BOTH SIDE OF THE 2 METAL SHEETS
- 18 -
Resistance Welding Solutions

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Inverter as25-15k

Tabla de contenido