Operating Controls; Indicator Lights - KENMORE ELITE SENSOR SMART 110.70092991 Manual Del Propietario E Instrucciones De Instalación

OPERATING CONTROLS

START
Use this control to start the dryer. Be sure
the dryer door is closed. Opening the
door stops the dryer. It will not start again
until you close the door and press
START.
NOTE: If you do not close the dryer door
and press START within 5 minutes of
when the dryer door was opened, the
dryer will shut off. You will have to select
a new cycle to restart the dryer.
STOP/CANCEL
Use this control to temporarily stop
(pause) the cycle.
• If STOP/CANCEL is pressed once and
you open the dryer door, you must close
the door and press START to restart the
dryer (see NOTE above).
• If STOP/CANCEL is pressed once and
you leave the dryer door closed, you
can press START to continue the cycle.
• To cancel the cycle, press
STOP/CANCEL twice. Pressing
STOP/CANCEL will not erase the
CUSTOM SET settings.

INDICATOR LIGHTS

CYCLE LIGHTS
Located next to each pad under SELECT
CYCLE, these lights show the cycle you
have selected.
DISPLAY LIGHTS
These lights show the level of dryness
selected, temperature settings and
estimated or actual drying time.
OPTIONS LIGHTS
These lights show when DAMP DRY
SIGNAL , WRINKLE GUARD
TOUCH UP have been selected.
32
STATUS LIGHTS
Located on the right side of the console,
these lights show what portion of the cycle
the dryer is operating.
CHECK LINT SCREEN
A properly cleaned lint screen will
allow your dryer to operate at peak
efficiency. This can reduce your utility
bills and extend the life of your dryer.
Once a cycle is selected, the CHECK
LINT SCREEN light will flash to remind
you to clean the lint screen. The light will
flash for up to 5 minutes, or until the door
is opened, or START is pressed.
Clean the lint screen before starting each
load. If you do not, your dryer may not
operate properly.
® III or