Replacing The Fuse - Chauvet Professional Amhaze Whisper Guía De Referencia Rápida

Amhaze Whisper QRG
Contact
What Is
Included
AC Power
AC Plug

Replacing The Fuse

DMX Linking
DMX Connection
Preparing for
Operation
Use the information in
UK, Ireland, or Mexico, contact the distributor of record to request support or
return a product.
·
Amhaze Whisper
·
Seetronic® powerkon True 1
power cord
This product has a fixed voltage power supply and it can work with an input
voltage of either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific
model.
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Amhaze Whisper will work with a DMX controller using a 3- or 5-pin DMX
serial connection.
www.chauvetprofessional.com.
The Amhaze Whisper uses a 3- or 5-pin DMX data connection for its 2-channel
DMX personality. See the User Manual for information about connecting and
configuring the product for DMX operation.
To prepare the Amhaze Whisper for operation:
1. Open the flight case.
2. Pull out the fluid tank and remove the cap.
3. Verify that the two plastic hoses attached to the inside of the cap are in place
and in good condition.
4. Pour Chauvet PHF haze fluid inside the tank, and re-cap.
5. Reinsert the tank.
6. Make sure that the plastic hose that goes from the cap to the hazer is not bent.
7. Plug in power and wait approximately 30 seconds for warm-up to complete.
Only use Chauvet approved PHF haze fluid. Otherwise, you might not have
satisfactory results. In addition, unapproved fluid can damage the Amhaze
Whisper or cause harm to humans or animals.
When storing the product, ALWAYS be sure to store the fluid tank with the
cap up as seen on the Product Mounting Diagram above before installing the
front cover to avoid tube damage that may cause leakage.
Contact Us at the end of this QRG. From outside the U.S.,
·
·
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow
A DMX
3
Warranty Card
Quick Reference Guide
Screw Color
Brown Yellow/Brass
Blue
Green/Yellow
Primer is available
EN
Silver
Green
from