Installation - Samsung SCC-B5351 Guia Del Usuario

Function Switches
1.L/L 2.FL
SW1
The camera operates in Internal Synchronization
mode when the switch is set to OFF and in Line-Lock
Synchronization mode when the switch is set to ON.
❈ Operating mode is set to lnternal Synchronization
Mode when using the DC12V power supply,
regardless of the L/L switch status.
SW2
Functions to prevent flicker for NTSC systems in areas
with a 50Hz power frequency, and for PAL systems in
areas with a 60Hz power frequency. Flicker occurs
when there is a mismatch between the vertical
synchronizing frequency and lighting control
frequency. When SW2 is set to ON, the electronic
shutter speed is fixed either to 1/100 seconds (NTSC)
or 1/120 seconds (PAL).
Iris Level Control
Use the screwdriver-like adjusting rod to turn the VR
and control the lris level.
6
User Guide

4. Installation

I
Check what is inside the package
• Check to see if the following parts are included in
the purchased package.
tab screw
STOPPER
Camera
PIN
I
Notes on installation and usage
1. Users should not disassemble the camera from
the front direction.
2. Always handle the camera with care. Please do
not apply a shock or vibration as much as possible
and take cautions not to cause damage or make a
scratch on the camera due to careless storage.
3. Please do not install the camera with the rainy
place or highly humid areas. And do not operate
the camera in the wet place.
4. Do not clean the camera body with the strong
abrasives or soaps. When the camera becomes
dirty, clean it with the dry rugs. Especially, make
sure to use the dedicated rugs for lens to clean
the dome cover.
5. Please keep the camera at the cool area that is
not exposed to the direct sunlight. If you do, it can
cause bad effects on the product.
7
User Guide
E
BRACKET
User's guide