Mounting Rails; Adjusting Mounting Rail Depth; Wall Mounting The Enclosure; Mounting - Tripp-Lite SmartRack SRW Serie Manual Del Propietário

5. Enclosure Configuration

5.4 Mounting Rails

The enclosure comes with mounting rails that have both square and tapped holes for mounting rack
equipment. To install equipment, use the included cage nuts and other hardware. (See section 7.1
for installation of cage nuts.) Warning: Be sure to have the enclosure securely mounted to the
wall, or in its final position on the floor, before mounting any equipment inside. Also be
sure to have all the right adjustments on your rails before mounting equipment. (See below
for Adjusting Mounting Rail Depth.)

5.5 Adjusting Mounting Rail Depth

Warning: Do not attempt to adjust rails while equipment is installed in the enclosure. Do
not attempt to use rails without screws installed. (2 per rail.)
Depending on the model, either two or four mounting rails will be pre-installed in the cabinet. The
preset mounting depth varies based on the model. Do not adjust the mounting rails unless your
equipment requires a different mounting depth. The front and rear sets of rails can be adjusted
independently in 1/4-inch (6mm) increments.
1 Each rail is connected to the enclosure with 2 screws and 2 cage nuts: 1 set in the upper
corner and another in the lower corner. Using a Phillips-head screwdriver, remove the screws
that fasten the rails to the enclosure.
Move cage nuts to the desired depth and reinstall.
2
3 Slide the mounting rails to the desired depth and reattach them using the screws you removed in
Step 1.

6. Wall Mounting the Enclosure

Warning: Do not attempt to mount the enclosure to the wall with equipment in the enclosure.

6.1 Mounting

The number of keyhole cutouts on the back door of the enclosure will vary based on your model.
Each keyhole can accommodate an M8, M10, 5/16" or 3/8" bolt. The holes are centered 16"
apart horizontally to accommodate the standard placement of wall studs. The vertical distance
between the holes will vary based on your model.
Note: Enclosure must be installed by a qualified technician. Before mounting, use a level and tape measure
to position your mounting area precisely. Use appropriate fasteners (not included) to secure the enclosure to
the wall. A minimum of four fasteners and appropriately-sized fender washers is recommended. Use suitable
mounting means when installing to cinder block, concrete, drywall or wood studs. Warning: The supporting
surface must be able to safely support the combined load of the equipment and all attached
hardware and components. For the actual weight, size and load capacity of the enclosure, view the
product specifications and other support resources at www.tripplite.com/support.
( continued )
5
1
16"
16"
16"
16"
Your model's keyhole configuration
may be different.
2
3
Variable