Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
problem
Engine fails to start
Engine lacks power
Excessive vibration
Mower will not mulch grass
Uneven cut
Mower will not self propel
TROUBLESHOOTING
Cause
1.
Blade control disengaged.
2.
Spark plug boot disconnected.
3.
Fuel tank empty or stale fuel.
4.
Fuel valve is OFF.
5.
Choke is OFF.
6.
Faulty spark plug.
7.
Spark plug wet with fuel (flooded engine).
8.
Fuel filter clogged, carburetor malfunction,
ignition malfunction, valves stuck, etc.
1.
Air filter clogged.
2.
Bad fuel; engine stored without treating the
gasoline, or refueled with bad gasoline.
3.
Fuel filter clogged, carburetor malfunction,
ignition malfunction, valves stuck, etc.
1.
Cutting blade loose or unbalanced.
2.
Bent cutting blade.
1.
Wet grass.
2.
Excessively high grass.
3.
Dull blade.
1.
Wheels not positioned correctly.
2.
Dull blade.
1.
Belt not installed properly.
2.
Debris clogging drive operation.
3.
Damaged or worn belt.
NEED MORE HELP?
Find this and all your other product manuals online.
Get answers from our team of home experts.
Get a personalized maintenance plan for your home.
Find information and tools to help with home projects.
1.
Engage blade control.
2.
Connect wire to spark boot.
3.
Fill tank with clean, fresh gasoline.
4.
Move the fuel valve lever to ON as instructed in the
Operation section.
5.
Unless the engine is warm, move choke lever to the
CHOKE ON position.
6.
Clean, adjust gap, or replace.
7.
Dry and reinstall the spark plug. Start the engine with
the choke lever in the OFF position.
8.
Contact your Sears Service Center.
1.
Clean or replace the air filter.
2.
Fill tank with clean, fresh gasoline.
3.
Contact your Sears Service Center.
1.
Tighten blade and adapter. Balance blade.
2.
Contact your Sears Service Center.
1.
Do not mow when grass is wet; wait until
later to cut.
2.
Mow once at a high cutting height, then mow again
at desired height or make a narrower cutting path.
3.
Sharpen or replace blade.
1.
Place all four wheels in same height position.
2.
Sharpen or replace blade.
1.
Check belt for proper pulley installation and
movement.
2.
Stop engine, disconnect spark plug boot,
and clean out debris.
3.
Replace belt.
managemyhome.com – for free!
22
remedy
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
